Attached is the RSLogix 5000 file as well. There is one 1794-TB3 connected with a 1794-IB8S I just can't seem to figure out what I am missing.
![citect controllogix plc5 map tags citect controllogix plc5 map tags](https://docplayer.net/docs-images/65/53904074/images/46-0.jpg)
Both Channel A and B are setup for RIO on the 1756-DHRIO Channel A is addressed as "01" and Channel B is "02" Status Window states "A IO SCAN, A OK, B IO SCAN, OFF LINE" (B is not connected / not being used) Channel A Light is Flashing Red Channel B Light is Off Power LED is On Green 1794-ASB Switch 1, 1=on, 2=on, 3=on, 4=on, 5=on, 6=on, 7=on, 8=on Switch 2, 1=on, 2=on, 3=on, 4=on, 5=on, 6=on, 7=off, 8=on I/O Rack number should be 0 First I/O Group should be 0 Baud should be 57.6k All LEDs are off, they turn on temporarily on power up. I have the "Blue Hose" with 150 Ohm Resistor on each end with a total Length of 10 feet.
CITECT CONTROLLOGIX PLC5 MAP TAGS CODE
The 1794-ASB shows IO Faulted, Module Fault Code 16#0312 Connection Request Error: Invalid Link Address. I am using a Control Logix 1756-DHRIO Ser.
![citect controllogix plc5 map tags citect controllogix plc5 map tags](https://docplayer.net/docs-images/63/49691805/images/13-1.jpg)
I think I am Brain Dead today, or it has just been too long since I've played with RIO. I am just wondering if one of my workmates who had worked on it earlier - who is not familiar with AB PLC - had done someting silly and is hidding it from me.Ĭan anyone please help me resolve my issue. This is preventing me from going On-line to clear the faults and restore the missing graphics. When attempting to go On-Line, this message is also popping up: "The current security connection is no longer valid." 'You are not authorised to perform this operation(Communications Configuration).'" However, when attempting to verify communication on the RsLogix 500 under Communication Tab, I have this message popping up: "RsLogix 500 Security Violation. I connected my laptop PC on which RsLogix 500 is installed, and verified Ethernet communication between the PLC and the laptop from RSLINX Lite.
![citect controllogix plc5 map tags citect controllogix plc5 map tags](https://docplayer.net/docs-images/39/18257293/images/26-0.png)
I have to restore the missing graphics to have the equipment back running. I now have a problem where several graphics on the main graphics page are missing, thus preventing Control Room Operators running the equipment (Filter Press). I have AB SLC05/5 PLC controlling Metso Filter Press with Citect SCADA version 6.10.